I am trying to figure out why after I go WOT and let off the throttle the truck continues to accelerate for about 1/2 second - logs clearly show pedal at 0% but throttle at >50% tune and logs attached...
not sure if the Max TQ Feedback and CSER ETC Feedback being disable is "normal"
any thoughts on how to attack this?
Last edited by eriktreves; 09-25-2023 at 02:49 PM.
I had this happen once and it was a bad flash. Went back 1 revision and it was gone.
TQ tables, trims being 20% off, trans limit...a lot to check. Log TB angle, remove unnecessary PIDs to improve polling.
v-performance.pl/
facebook.com/veee.performance/
https://www.instagram.com/v.performance.pl/
Remote tuning:
[email protected]
+48 697276579
Ive seen this when TQ tables are set too high for that given map point
2009.5 PBM G8 GXP M6 W/Roof-Self tune, OBX LTs, Kooks axleback, LSA blower, cam,
Monster LT1-SC clutch, flex fuel, 12 psi [email protected] 1,800 D.A
2007 TBSS-Self tune, bolt ons [email protected], 1,900 D.A
1991 GMC Syclone- Self tune/catback 12.8@104, 4,200ft D.A
Reply With Quote