I'm trying to read my transmission on vcm editor but it doesn't let me. When I read normally and go to the transmission tab, it's blank. I'm trying to read only my transmission but I don't even have an option for that. There's no way there's no transmission options for a 2018 so what am I doing wrong? Thanks!
I suggest opening a ticket at HP Tuners ([email protected]) explaining your issue.
DodgeBoy.
YouTube: https://www.youtube.com/@dodgeboy2785
Do you have the By-pass cable installed?
www.n2speed.com
http://www.amp4x4.com
[email protected]
Dodge And GM Tuning Suppport
Diablosport CMR | HP Tuners
Very good point N2Speed...
Link: https://www.hptuners.com/product/dod...-access-cable/
Yes I doOriginally Posted by N2speed
I've been reading and writing tunes I have it
bump, just boosted the car need to tune trans and still unable to. I've been trying to contact support for the past couple of months, no response.
Can you post a screen shot of the VCM Editor when you try and read it?
www.n2speed.com
http://www.amp4x4.com
[email protected]
Dodge And GM Tuning Suppport
Diablosport CMR | HP Tuners
I don't have my car nor mpv but I think I have a picture of that, let me check.
You have to select the hardware. What version of the software are you using
Michael Bray
Rusty Knuckle Garage
Slidell, Louisiana
20yr Master Tech.
Advanced Level Specialist
Custom Car Fabrication, Customization, High Performance.
GM World Class Technician
Shop Owner
I'm pretty sure hardware was blank as well, I'm using version 5.0.4
Did you pay the credits for the trans?
2019 challenger rt
k&N cold air intake
92mm hellcat throttlebody
ported 392 intake manifold
ported eagle heads
Cammotion custom 222/234 cam
stainless works long tube headers and catless mid pipes
3' catback with h-pipe & pypes violator mufflers
e-85 tuned
3.70 lsd
Is it separate from the ecu? I bought the mpvi3 with 2 credits
Yes
2019 challenger rt
k&N cold air intake
92mm hellcat throttlebody
ported 392 intake manifold
ported eagle heads
Cammotion custom 222/234 cam
stainless works long tube headers and catless mid pipes
3' catback with h-pipe & pypes violator mufflers
e-85 tuned
3.70 lsd
I believe ZF 8HP requires four credits (normally).
When you say four credits do you mean I need to buy four more credits for that itself or just two more since I already have two?
So I just buy more credits and redeem them and my tcm is unlocked?
I would believe all 4 credits need to be addressed to the correct/same controller (which is ZF 8HP TCU).
Once another 2 addressed, it should work. If not, maybe get in touch with hp tuners support service.
Link: https://www.hptuners.com/vehicles/stellantis-tuning/
Look at "DODGE/CHRYSLER/JEEP/RAM TRANSMISSION CONTROLLERS" => "18-23 ZF8HP2 8-Speed Transmission Control Module (TCM) 4"
Reply With Quote
