I have a 2016 dodge charger 3.6 that i installed a ripp supercharger on. After install and with the base tune, the vehicle ran great. After getting it tuned, the vehicle made 440rwhp, with that in mind, i imagine the vehicle made 460hp+ to the engine. The car also had a stock exhaust with flowmaster mufflers.
Recently, i de-cat the vehicle and installed a 2.62" pulley from the 2.87" pulley that came with the supercharger. After the de-cat, the afr began the run rich. So after a few videos and a wide-band sensor install, i taught myself how to adjust the afr. After a few test drives and logs, i added a hp calculator and the engine is only making about 390hp. I tried adjusting the spark table at wot but cant seem to figure out which table or what the correct process is to adjust spark. I've added 7 degrees to wot but haven't seen a change anywhere. No change in hp or a change in the actual spark pid.
Main thing i need help with is someone showing me how to adjust spark any information is appreciated. Want some help before i keep adding and blow something up.
Thanks
-steven
p.s. I disabled the neural network