Gen 5 6L80 logs

[GMJosh]

I'm out of my wheelhouse here so excuse my ignorance if this isn't possible! I'm tuning my 6L80 after a TC install. Following a YouTube video from Matt Sanford. It feels much better than it did before but 2-3 shift is a little funky. It shifts fine, initially, but after the shift the rpms drop a few hundred rpms again. Almost like it went into 4th. I saw where I can data log via VCM Scanner. Would someone be able to see this through some type of graphs and possibly diagnose the issue? I have my tune attached as well as a log file that shows the rpm drop. Again, I'm new to this. Let me know if there are different graphs I can/should be including a log file.

Tune: Shift points round 2.hpt


Data Log: 1st.hpl

[TransGo Robert]

I'm out of my wheelhouse here so excuse my ignorance if this isn't possible! I'm tuning my 6L80 after a TC install. Following a YouTube video from Matt Sanford. It feels much better than it did before but 2-3 shift is a little funky. It shifts fine, initially, but after the shift the rpms drop a few hundred rpms again. Almost like it went into 4th. I saw where I can data log via VCM Scanner. Would someone be able to see this through some type of graphs and possibly diagnose the issue? I have my tune attached as well as a log file that shows the rpm drop. Again, I'm new to this. Let me know if there are different graphs I can/should be including a log file.

Tune: Shift points round 2.hpt


Data Log: 1st.hpl

That log is not going to be helpful for the transmission because you did not log most of the transmission channels.
Here's a Channel configuration that should give us all the PIDs we need to help you.
6L80 PIDs.Channels.xml