Im about to go insane trying to figure this one out. So much info to sift through i end up down so many rabbit holes. 2016 silverado l83 with 6l80. Trans was just rebuilt. Engine has a TSP dod/afm delete stage 1 cam, ls lifters and a 0 degree phase limiter on it. I have cam card if needed. issue im having is (ill try and explain this best i can) rich to lean issue while tuning VVE tables with a Wideband. been trying to tune this for months now and just chasing my tail so there has to be something im missing. so when i log a run it will be rich on the low end and lean up toward WOT. So i copy and paste multiply by half and log another run, and it will have swapped lean low end, rich at wot. and ive tried extrapolating out and smothing it out, adjusted my zones and nothing seems to help. I have done a compression test, checked coils and spark plugs, and checked wiring for fuel injectors. In HP tuners i have gone through and shut off fuel injectors to make sure the are working and they all seem fine at idle. went through my data logs and everything seems to be working correctly. Im assuming its something in my tune itself the i did or didnt do. Ill attach my current tune if anyone has some free time to go through it. couple of last min concerns ive heard that when you DOD and VVT delete there are several things that need to be changed in the tune and not sure ive got them all, also my VVE coefficient table has changed from my original baseline tune which i will post as well (FYI i do not have the stock tune as i sent the ECM off to have a base tune in it so all i have is whatever they did to the tune. and no idea what they actually changed. I will also add my last log file so you can see what it is doing. Hopefully that all makes sense and someone on here can help me out. Thank you in advance.