Brand new to e90 ecm tuning, have a stock engine with btr dod delete kit. Ecm has already been sent off and i have the stock tune file but i am lost on where and or what to do o turn dod off? Any help would be greatlappreciated.
Brand new to e90 ecm tuning, have a stock engine with btr dod delete kit. Ecm has already been sent off and i have the stock tune file but i am lost on where and or what to do o turn dod off? Any help would be greatlappreciated.
Just DOD? It's the rpm settings under the Fuel tab.
Last edited by GHuggins; 02-06-2024 at 02:16 PM.
2010 Vette Stock Bottom LS3 - LS2 APS Twin Turbo Kit, Trick Flow Heads and Custom Cam - 12psi - 714rwhp and 820rwtq / 100hp Nitrous Shot starting at 3000 rpms - 948rwhp and 1044rwtq still on 93
2011 Vette Cam Only Internal Mod in stock LS3 -- YSI @ 18psi - 811rwhp on 93 / 926rwhp on E60 & 1008rwhp with a 50 shot of nitrous all through a 6L80
~Greg Huggins~
Remote Tuning Available at gh[email protected]
Mobile Tuning Available for North Georgia and WNC
thanks for the reply i looked under the variable cam table but i have not seen the rpm setting or tab that you are talking about. I did see something that says misc desired angle and it has a smaller tab that says high dod is that were you are refering to? It has the rpm graph would i just zero that out?Originally Posted by ghuggins
Sorry, it's under Fuel, not cam - lean fuel setting - Leave as sliding if still variable cam too -
Last edited by GHuggins; 02-06-2024 at 02:17 PM. Reason: corrected my earlier post
2010 Vette Stock Bottom LS3 - LS2 APS Twin Turbo Kit, Trick Flow Heads and Custom Cam - 12psi - 714rwhp and 820rwtq / 100hp Nitrous Shot starting at 3000 rpms - 948rwhp and 1044rwtq still on 93
2011 Vette Cam Only Internal Mod in stock LS3 -- YSI @ 18psi - 811rwhp on 93 / 926rwhp on E60 & 1008rwhp with a 50 shot of nitrous all through a 6L80
~Greg Huggins~
Remote Tuning Available at gh[email protected]
Mobile Tuning Available for North Georgia and WNC
Would i just put rpm to 1 or something low
The picture I posted is out of one of the one's I've done. Just set it to 0. Leave sliding as sliding if running variable cam.
2010 Vette Stock Bottom LS3 - LS2 APS Twin Turbo Kit, Trick Flow Heads and Custom Cam - 12psi - 714rwhp and 820rwtq / 100hp Nitrous Shot starting at 3000 rpms - 948rwhp and 1044rwtq still on 93
2011 Vette Cam Only Internal Mod in stock LS3 -- YSI @ 18psi - 811rwhp on 93 / 926rwhp on E60 & 1008rwhp with a 50 shot of nitrous all through a 6L80
~Greg Huggins~
Remote Tuning Available at gh[email protected]
Mobile Tuning Available for North Georgia and WNC
Sorry didnt see the picture. I will try that in the morning thanks a million times over
Hello im attempting to do the same but i dont have the option for lean/fuel.
Reply With Quote