-
Tuner in Training
prolink+ 0-5v sensor
I am trying to setup a fuel pressure and oil pressure gauge through the two prolink analog inputs, using 0-5v, 0-100psi transducers.
If I am understanding this correctly;
Connect signal wires from transducers to prolink
Connect ground wires from transducers to prolink
Connect 12v (ignition on) to transducers
Following the hpt directions for transforming voltage into sensor data.
I dont like doing wiring twice so just wanted to nail down a procedure before attempting, so any tips would be helpful. Thanks
-
Your transducers are designed for 12V in and 5V out?
-
Tuner in Training
ahh no lol. Where would I get 5v from to send to the sensor?
-
Any of the 5V wires already going to any of the original 3-wire sensors on the vehicle?
-
Tuner in Training