ok so I'm doing a swap with a stand alone harness, engine is out of a 2008 avalanche LC9 and transmission is out of a 2015 chevy tahoe 6L802wd. I have the E38 and T46 computers out of a 2009 chevy suburban with factory LC9 and 6L80 4wd. I deleted vats turned off DOD and did a complete write. but I can't get any RPM signal. I have checked and the power wire for the harness is getting from 10 to 12 while I'm cranking. I have power and ground at the coils, I haven't check while cranking, also I have no fuel pressure (I have no lines hookup yet). at the crack position sensor I'm getting 5v on A, ground on B and 5v on C. not sure what else it could be unless I screw something with the tune. if somebody can help I'm attaching the tune or if you have any other Idea of what can I check. one more thing the maf is a 213-4222 and map is factory 12594942. any help is appreciated.
Samurai1.hpt