Still getting unsupported interface on my mercury LSE.
Maybe its not part of the supported in this beta?
2MEHM75W03X606268
Strategy: RZA01
PartNumber: 3W7AADB
Filename: RZA01HW
Thanks in advance for all ya'lls work on this.hptuners beta.png
Still getting unsupported interface on my mercury LSE.
Maybe its not part of the supported in this beta?
2MEHM75W03X606268
Strategy: RZA01
PartNumber: 3W7AADB
Filename: RZA01HW
Thanks in advance for all ya'lls work on this.hptuners beta.png
Unsupported Interface means you have an MPVI3 hooked up but do not have the EEC-V specific firmware on your device. Get me the device serial number and send it via the forum private message system and I'll get you added.
Eric Brooks
HP Tuners, LLC
My device was added to the firmware list a while back. I cannot get it to read an 03 mustang. It's a v6 code UVB0.
It will not open the file after it reads
Email it to [email protected] and it will be added.
Eric Brooks
HP Tuners, LLC
Good morning Eric. Looking for some firmware sir. I tried reading a 2004 Mustang Cobra Terminator and nope
mpc-14c
4r3a-12a650-aab
ee0fa 4b18b
fbgh0cd - operating system
VCMSuiteInfo.txt
Hey Eric im based over in New Zealand wondering if you would be able to support AU falcons which has the same motor as your domestic Foxbody 5.0 V8 windsor
Cheers Casey
Hey Casey,
Have already been working with him to get AU6 support. Good chance V8s can get support too.
Waiting to be added to the Beta to get an AU6 read.
Rob
Hey Rob sounds great I also have an AU6 VCT would be great to see how you progress do you have someplace I can contact you to stay updated with how you progress?
Cheers Casey
Hey Casey,
Flick me a message via my website contact details / forum.
https://www.midnightuning.shop
I've already got AU6's near fully open source tunable via my public defs and J3's or other flash methods.
-Rob
Haven't forgotten about you guys. I do EEC stuff in between other big projects. I'll get some Aussie vehicles added ASAP.
Eric Brooks
HP Tuners, LLC
All good Eric. I saw you PM replied but it was blank, can imagine your fairly busy. I'll try take another read of the AU and get you a .hpt
Hey Eric,
No luck reading the AU. Detect protocol failure.
Seems I'm in the Beta as there is no unsupported interface.
AU is PWM Bus for ECU comms. Other devices are low speed comms (ISO)
-Rob