afr500v2 can

[04silverado6.0]

Just setup my v2 can for obd, waiting on the adapter to come in. Ballenger software is locked at 1hz for hptuners. Will i be able to request faster polling in the scanner? Id think 25-50 would be much better polling rate.

[04silverado6.0]

Also, left my baud rate at 500kbps. Is that pretty standard or can i do better without stressing the wb or getting bad data?

[04silverado6.0]

Ive got it up and running but havent had time to sit and play with the new wb. Ill see if i can learn more about it tomorrow and post back for the next guy. Just a bonus it will not poll the parameter if the obd2 passthrough is laying in the passenger side floor.
EDIT: forgot to play with unit
Loving the can unit for sure, not so sure about the bosch 4.9 i let calibrate 45-50 minutes. Seems more rich than normal compared to my dyno wb. Ill keep using the 4.9 on the 6 TN or chopacabra build i tune per week and eventually get a ntk and do some real cal work. Anybody questioning a can v3 unit definitely order the thing.

[morganf]

1hz is not used by the AFR500 in HPTuners mode as OBD2 is request/response, If you want a faster rate you can right click on the channel and change the `Polling Interval`. The 500k Baud rate is not changeable OBD2 communications breaks if you change it, it's a set OBD2 standard.
polling.png

[04silverado6.0]

Thanks for the response. I have been using this a lot but have not adjusted polling interval. Whatever default is seems to be working fine. I completely forgot to play with it as the response seems just fine.

[04silverado6.0]

If they end up having good support for the bosch adv id like to upgrade to a v3.