Results 1 to 5 of 5

Thread: Can't find Torque Management Parameter

  1. #1

    Question Can't find Torque Management Parameter

    Hey guys quick question, while watching a few videos online about logging the virtual torque tuning parameters in the scanner, I saw somebody using one literally just labeled torque management. In degrees it told you how much torque was being pulled at a given time. Seems simple enough, however when I go to my channels list and search for it I CANNOT find it. I've looked under everything. I can find the predicted engine torque, immediate etc.. but not plain old Tq Mgt. I made sure my software is up to date. This is on a gen v controller. Does anybody know how to get this added?
    Attached Images Attached Images

  2. #2
    Tuner in Training Balakayt.'s Avatar
    Join Date
    Jul 2024
    Location
    DFW, Texas
    Posts
    34
    if it was reading in degrees it was probably the torque management advance channel.

  3. #3
    Senior Tuner
    Join Date
    Nov 2017
    Posts
    2,153
    It all depends on what vehicle you are tuning. Videos that don’t match your ECM are almost worthless.

  4. #4
    Senior Tuner
    Join Date
    Jan 2022
    Location
    fountain valley
    Posts
    1,232
    almost?
    [email protected]

    don tanklage

  5. #5
    Senior Tuner
    Join Date
    Nov 2017
    Posts
    2,153
    Quote Originally Posted by LilSick View Post
    almost?
    If you know nothing it can help you learn some general ideas about tuning. Sometime. Rarely?