Can't find Torque Management Parameter

[[email protected]]

Hey guys quick question, while watching a few videos online about logging the virtual torque tuning parameters in the scanner, I saw somebody using one literally just labeled torque management. In degrees it told you how much torque was being pulled at a given time. Seems simple enough, however when I go to my channels list and search for it I CANNOT find it. I've looked under everything. I can find the predicted engine torque, immediate etc.. but not plain old Tq Mgt. I made sure my software is up to date. This is on a gen v controller. Does anybody know how to get this added?

[Balakayt.]

if it was reading in degrees it was probably the torque management advance channel.

[gtstorey]

It all depends on what vehicle you are tuning. Videos that don’t match your ECM are almost worthless.

[LilSick]

almost?

[gtstorey]

almost?

If you know nothing it can help you learn some general ideas about tuning. Sometime. Rarely?