2008 5.7 Cammed Hemi tune

[[email protected]]

Hi all just acquired my HPtuners MPVI3 and am trying to tune my cammed 2008 5.7Hemi in an 70 Cuda
I am idling reasonably ok in P/N, but sometimes hunting for idle (mostly happens when reaching running temperature)
Drives well on D, but dying at intersection/stops

Can someone help with Tune files to start with please!!!

Configuration:
5.7 no VVT non MDS
COMP Cam XFI 224/228 Hydraulic Roller Cam for Dodge HEMI 5.7L/6.1L 2003+
Intake Duration 273
Exhaust Duration 277
Intake Duration at .050 Inch Lift 224
Exhaust Duration at .050 Inch Lift 228
Intake Valve Lift 0.547
Exhaust Valve Lift 0.55
Lobe Lift Intake 0.342
Lobe Lift Exhaust 0.346
A727 Tranny HPTuners set to Manual Transmission Enabled
Only 2 O2 sensors in Exhaust Manifold ... 3" straight exhaust
OEM Gas pump

[MI_Tuning]

Hi all just acquired my HPtuners MPVI3 and am trying to tune my cammed 2008 5.7Hemi in an 70 Cuda
I am idling reasonably ok in P/N, but sometimes hunting for idle (mostly happens when reaching running temperature)
Drives well on D, but dying at intersection/stops

Can someone help with Tune files to start with please!!!

Configuration:
5.7 no VVT non MDS
COMP Cam XFI 224/228 Hydraulic Roller Cam for Dodge HEMI 5.7L/6.1L 2003+
Intake Duration 273
Exhaust Duration 277
Intake Duration at .050 Inch Lift 224
Exhaust Duration at .050 Inch Lift 228
Intake Valve Lift 0.547
Exhaust Valve Lift 0.55
Lobe Lift Intake 0.342
Lobe Lift Exhaust 0.346
A727 Tranny HPTuners set to Manual Transmission Enabled
Only 2 O2 sensors in Exhaust Manifold ... 3" straight exhaust
OEM Gas pump

are you looking for a base map or somebody to tune it for you ?

[[email protected]]

Base tune would be good ...

[StupidJeep]

I might start with Min Air Flow table in the bottom three columns. Either Add or subtract and see if that helps.

[JohnnyFW]

post your stock file and ill make you one that should be close

[[email protected]]

Hemicuda original.hptHemicuda 1.hpt

Thanks JohnnyFW
Attaching two files
Hemicuda original is the stock file
Hemicuda 1 is an attempt that was slightly better but still same symptoms.

[[email protected]]

post your stock file and ill make you one that should be close

Thanks JohnnyFW appreciate the support

[[email protected]]

I might start with Min Air Flow table in the bottom three columns. Either Add or subtract and see if that helps.

Thanks SJ will give it a try also

[JohnnyFW]

try this these ve tables are for comp cam stage 2 you will still need to adjust them but it should be pretty close i think

Hemicuda 2.hpt

[[email protected]]

try this these ve tables are for comp cam stage 2 you will still need to adjust them but it should be pretty close i think

Hemicuda 2.hpt

Thanks Johnny will load it up and let you know