Trying to tune out the rear O2 sensors on my 99 Dakota R/T. I have all available DTC disabled, but it will still pop Bank 1 sensor 2 and bank 1 sensors 3 heater circuit malfuction P0141 and P0145, because those DTC dont show up in HPtuners. is there a way I can get those DTC to show up so I can disable them?
Leave the wires for rear sensor plugged in
Unscrew the sensor and hang it under your truck
Put a plug in the hole
-Try going Engine ; Fuel ; Oxygen Sensor the disable heater .
But it will probably will turn off Sensor 1 heater as well
I found that in an older post .
-On my side , I'm looking to turn off those O2 sensor (sensor 2)codes but the line under DTC is Greyed out I can't select disable
A friend and I are swapping a 5.9 in a '76 Dodge Aspen Thanks .
Have you tried taking the HP Tuners emissions training class to gain access to emission settings?
2023 Dodge Durango R/T (5.7L) with Tow & Go Package (build thread)
Gen 5x Whipple 3.0L Supercharger
Smooth Boost Electronic Boost Controller
SRT 392 Air Intake Conversion
92mm Hellcat Throttle Body
Mighty Mouse Mild SRT Catch Can Setup
I did , would this be a cookie on my computer or just me login in HP tuner would work ?
I might have done it on my laptop . This moment I am on home desktop .
Thank you so much , I will double check .
What I got my new computer I emailed the parameter access file to myself
It's already set to disabledOriginally Posted by RoadBoss2
There is no hole in the exhaust, and this doeent fix the issue with the missing DTC in the editor
Reply With Quote