Tsp stg 2 cam & mds delete first start up help!!

[KILLSWITCH]

Hi Everyone

As the title suggests i have torn down my Ram 1500 5.7 hemi, new lifters, valves, oil pump, cam phaser locked and stage 2 TSP cam, I will have it back together this weekend, BUT can I turn it over without any PCM modifications or will it damage my engine? I guess I will need to adjust the idle, but any pointers or don't even crank it over?

Thanks in advance!
https://forum.hptuners.com/images/smilies/hi.gif

[MadhousePerformance]

You can turn it over and start it it will be pissed off but should run a few seconds. i would suggest turning the engine over on a relay jumper so you can get oil from the bottom to the top of the engine. That way when you do start it it wont make as much noise. When your ready load in stock file and ask for help some not all but some will not ask you for money to help you on your tune.

[KILLSWITCH]

You can turn it over and start it it will be pissed off but should run a few seconds. i would suggest turning the engine over on a relay jumper so you can get oil from the bottom to the top of the engine. That way when you do start it it wont make as much noise. When your ready load in stock file and ask for help some not all but some will not ask you for money to help you on your tune.

I appreciate you coming back to me I'm just looking for help and have no problem paying for good sound advice/help, I believe you can hold your foot flat to the floor to turn it over not start to get the oil pressure up, its just the air ratio idle etc afterwards, im confused on.

[MadhousePerformance]

your correct its sometyhing ive seen others do but i like the relay way since it wont put fuel in the cylinder and that also cuts spark. but yead when its started you got some help

[KILLSWITCH]

your correct its sometyhing ive seen others do but i like the relay way since it wont put fuel in the cylinder and that also cuts spark. but yead when its started you got some help

ok so i got her started but she doesn't idle for long and sounds like the throttle body is trying to correct, she then stalls, I have to give it some gas to get her going again, I will read the stock file tonight, but I'm going in blind to be honest, I am not building this for a track, just need it to be reliable and punchy for the road/off road. Thanks in Advance!

[LilSick]

could you email me the oem read and the file that is in it right now?

thx

[KILLSWITCH]

LIL, sent!

thanks.

[Tymrow]

Did you end up getting it dialed in or got someone to tune it? I have the same setup and am looking for a base tune.

[N2speed]

Did you end up getting it dialed in or got someone to tune it? I have the same setup and am looking for a base tune.

I can help [email protected]

[John_Carter_2]

LIL, sent!

thanks.

Hello!
Could you share the tune here?

Thank you!

[Jarhead1985]

I?m need help with my 2013 dodge charger rt 5.7. I put a tsp chopacabra cam with mds delete and a wideband and long tube headers and cold air intake. Now she won?t idle and I haft to give her gas to start. I?m new to hp tuners and really need some help on tuning.

[LilSick]

both chris and i have our emails listed above

here it is again

\/ \/ \/

[DodgeBoy_8HP]

I?m need help with my 2013 dodge charger rt 5.7. I put a tsp chopacabra cam with mds delete and a wideband and long tube headers and cold air intake. Now she won?t idle and I haft to give her gas to start. I?m new to hp tuners and really need some help on tuning.

DO you have a tune and log to share?

[Jarhead1985]

I have the stock tune saved