How's it going everyone? I have a question. I'm new to tuning, I had my vehicle tuned by 2 shops in the past and recently had a more aggressive cam installed with a big converter. The car always had little issues here and there as far as running, but nothing major. Long story short I put the vehicle in MAF only mode, speed density is disabled, but the vehicle runs when the maf is disconnected and speed density is off. My major concern is the pid for hertz for my MAF frequency reading to tune the maf at idle is not reading at all. I'm on the latest software and I even tried it in the beta. Connected the scanner to another vehicle maf reads just fine. Got the pin outs for the maf checked all the signals / grounds everything is there. Checked the signals from the computer (for the maf) everything is ok, so my question is, is there something that could be potentially disabled within the editor that could cause the maf to not work? Keep in mind that speed density is already disabled and maf is the only thing enabled. Anything helps been stumped on this all week. Thank you all in advance.
Reply With Quote
