Tuning a Supercharged 2013 Land Cruiser

[njbrain]

I have a 2013 Toyota Land Cruiser with a 5.7 V8 and I just picked up a second hand supercharger for it. Magnuson won't sell me a tune as I didn't buy it new. I cannot use the Toyota TRD tune as it doesn't match calibration ID. I opened both calibration files in my HP tuner and attempted to copy and paste, but the stock Land Cruiser tune has 16 cell blocks wide throughout the torque tables, and the Tundra TRD tune has 20 blocks wide. Copy and paste will not work. Is there a good way to copy the TRD tune to the Land Cruiser?

[SlowNStock]

I have a 2013 Toyota Land Cruiser with a 5.7 V8 and I just picked up a second hand supercharger for it. Magnuson won't sell me a tune as I didn't buy it new. I cannot use the Toyota TRD tune as it doesn't match calibration ID. I opened both calibration files in my HP tuner and attempted to copy and paste, but the stock Land Cruiser tune has 16 cell blocks wide throughout the torque tables, and the Tundra TRD tune has 20 blocks wide. Copy and paste will not work. Is there a good way to copy the TRD tune to the Land Cruiser?

You can edit the axis values to get as many matching values as possible for each table, then trim off the excess, or interpolate the values from the TRD calibration to the LC200 table.

Post your file, I'll give you an example.

[njbrain]

Thank you. I was able to accomplish this after searching the forum for a while. I edited the axis values where I could, and copied and pasted the rows and columns where the axis numbers matched, and used the interpolate function to fill inbetween, and got a table that looks very much like the TRD.