lm1 and eio offset how to

[cfar]

I have set my scales in the lm1 to 0=10 and 5=18 afr.No advanced tab to scale sample rates.
The lm1 reads correct but the VCM reads 1.5 low
Tried a custom pid but must be doing it wrong-i have tried to follow the reads with no luck
any help -photo shots-and how to is appreciated
Where do you put the offset volatages-if i do it in user defined(.625 + 10)-its all wrong
I must be doing something wrong
thanks

[cfar]

got it finally-the learnig curve is steep

[exploder]

what did you do to fix it? Mine is 4 points off and I can't figure it out with everything I have read.

[cfar]

what did you do to fix it? Mine is 4 points off and I can't figure it out with everything I have read.

Change the formula in the user defined +10 area -
and retest accuracy -go up or down to nail it in
that is what i did
see this post-
http://www.hptuners.com/forum/showthread.php?t=5267

[S2H]

theres an even better writeup in the stickies with visuals..
much easier method

[INTHERED]

When I was setting up my LM1 to work with my Hptuner. I set the LM1 analog output 2 to a constant voltage to figure out my correction factor but
the data logged by the Hptuner was not a flat line like I expected it was a waveform that was sorta flat but varied around .164 Volts. Is this normal ?

Thanks >>>>> INTHERED