U0100 dodge no start condition

[Ben Charles]

Have an interesting one I?ve never witnessed before. Have a 14 dodge jeep I?ve flashes roughly 5-6x within about an hours time and went to flash the last touch up and now have a no start condition.

When attempting to scan the vehicle I get ?connected? vs the make model and Vin.
Rpm will jump from 0-16k, (sometimes can log ECT and few PIDs)

When attempting to re write file I either Get a
Control init NOT ready. OR
Control init Failed.

VCM log only shows TCM data with a u0100 (ink or this is common with flashing) but this is different I feel!

With key in Run position I get fast relay clicking as well!

Currently just trying to figure out what happen and what?s the fix

[blindsquirrel]

Dodges are notorious for bad grounds... and bad TIPMs. Sometimes stuff just breaks even if you haven't touched it.

[LilSick]

went to flash the last touch up and now have a no start condition.

Currently just trying to figure out what happen and what?s the fix

did the write complete or fail?

do you have the info.log?

[Ben Charles]

Wrote just fine… 10 second wait when write is done, complete then key on and nothing..

Buddies and Dodge came by, not able to recover it, going to need a new ECM. Never even heard of anyone bricking one of these? Freak thing, my guess is voltage issue, but who knows.
Worked on a 14 dodge truck with a cam yesterday, business as usual.

[LilSick]

oh its a thing

did you save the vcmsuiteinfo document before you wrote?

start a trouble ticket and attach that ^^^ and the oem read to it

you might be able to send the pcm to hpt and have them reflash it

save you a few hundred

depends one what is jammed up