Dumb quick question about prolink, mpvi2+ and analog inputs/common ground

[txsssedan]

Hi all. Setup is an mpvi2+, the prolink cable and using two different analog inputs on the prolink cable. I'll have two autometer sensors, and electric oil pressure gauge and a wideband o2. Each gauge has datalogging output, analog signal and ground. There's only one ground on the MPVI cable, so I'm assuming I'll be using a common ground between the two gauge datalogging outputs but just wanted to check. Told you it was a dumb question.

Thanks

Chris

[txsssedan]

Bueller?

Bueller?

[abc]

https://www.hptuners.com/help/VCM-Sc...pro_inputs.htm

[txsssedan]

Appreciate it, however I'm talking about the MPVI2+ cable that has 2 inputs and a single ground. I mean it looks obvious to me, I just wanted some clarification.

[LilSick]

the red and the blue inputs on a mpvi2 share a common ground

it is black

[txsssedan]

the red and the blue inputs on a mpvi2 share a common ground

it is black

That's what I was looking for. It's seems too obvious but I had to check. Thanks.