Simple matter I hope. This is for a n/a C6 Z06. I know the Chart Display will only display Sensors/PIDs I put into the Table Display as PIDs.
However there are three sensors I would like to display and can't seem to get the right PIDs associated, if any exist:
Fuel pressure, manifold vacuum, and Exhaust Temp.
Seems so simple I feel silly for asking, but I've looked all over the place. Thanks.
Fuel pressure & Exhaust Temp are EIO pids. If you have them listed in the EIO section they should be able to be added to the chart section.
Manifold Vac should be a standard PID so if you have it in the table it will be available for the chart.
Always Support Our Troops!
Just checked again. I can put them all in the chart, just no PIDs available for the table. Result = no readings.
make sure your running version 2.1.18
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Problem seems to affect v 2.1.18 also.
Sensor input is available for the chart, but no associated PID for the Table. Seems pretty basic oversight. Vacuum, Fuel pressure, exhaust temp.
If there was no PID for the speedometer for the table, it wouldn't produce a reading in the chart.
Can you update this oversight?
If its not available in the table display it means its not available.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Reply With Quote