04 GTP (V6) table issues/requests..

[johnh]

I finally got my application key.

I have looked at a couple of my .bin files in the VCM editor and I noticed a couple of settings that didn't seem right--meaning I had values set for those, but they came into VCM editor as 0.

I have modified the bin previously with other tools...

The tables in question is injector skew and TPS PE Enable Delay...

1. How do I report this as a possible issue? (This thread?)

2. How do I request new tables? There's still a few in some of the other tools that I'd like.

Thanks,

John

[Bill@HPTuners]

posting your tune would be helpful.

Requests go into the feature request section.

[johnh]

Here it is...

[johnh]

I noticed on the PE Enable Delay, the display value was 0, but the value when the cell was in edit mode was what it should have been .1 /.01 (value should be in seconds I am guessing). Any way to set the precision in the editor?

Injector skew is still all zeros.

[Russ K]

This is a pic of your Injector Pulse Width Skew & PE delay tables. The pic shows the increase precision button.

Russ Kemp

[Bill@HPTuners]

Give me a few minutes

[Bill@HPTuners]

http://www.thetuningdoctor.com/HPTun...eprecision.swf

[johnh]

Thanks I will look at the precision stuff.

BTW, my inj skews should be:

cyl 3 1.000, cyl 2 1.000 cyl 1 0.9800, cyl 6 0.9800 cyl 5 0.9900 cyl 4 1.0000

[Bill@HPTuners]

when I talk to Chris I'll have him look over your file for you.

Just so I understand, though, your pe delay is fine? Just the injector skew isnt matching what it should be correct?

[johnh]

Yes the PE delay is correct it was the precision display. Perhaps a nice feature would be to set the default precision to the last non-zero decimal place...That is if the number is 0.01250 the default precision would be three decimals.

The injector skew isn't matching.

[johnh]

Any updates?