Tuning Problems

[ezyride]

I'm a noobing so please bare with me

My setup
2001 3800GEN3 Turbo Charged in a 98 Grandam
converted to 5 speed

I'm running 60lb injectors
3bar map sensor. (i don't have a maf)

I was trying to tune and ran into a couple of problems..

1) i couldn't set my injectors (i tryed to set to a bigger injector it won't function it seem to lean out with the bigger number)
2) it didn't read my 3bar
3) I couldn't shut down my first 02

I clicked on the speed density tab in the airflow section and it was blank. (like this feature was disabled)

Also the Primary VE vs RPM vs MAP table was still set at 140KPA (shouldn't it be at @ 200-250)

I am currently stumped.. Can anyone help..?

PS. My file is currently at the dyno so i can't get access to it right away.
Also my dyno tuner is convinced that the VCM Editor has these feature locked out for V6 tuning.

[xonelith]

I don't think the V6 has 3 bar map support, however the injector scaling should work.

Someone with GTP experience should be able to answer those questions.

-xon

[98 SS]

somebody please tell me that the 01+ s-10 ecms will be able to have a 3bar SD os............ thats why i bought hpt

[Bill@HPTuners]

somebody please tell me that the 01+ s-10 ecms will be able to have a 3bar SD os............ thats why i bought hpt

The 4.3's support 2 & 3 bar for most if not all calibrations since they use the same pcm as LS1's.

[98 SS]

thats what I thought......just wanted to make sure