No mather if I use my config, on the Imperial, metric stock configuration
My reading from the map sensor isn't good
the car boost 14 psi
and I only ready 75 kpa
someone have an idea?
thanks for your help
No mather if I use my config, on the Imperial, metric stock configuration
My reading from the map sensor isn't good
the car boost 14 psi
and I only ready 75 kpa
someone have an idea?
thanks for your help
might consider posting a scan.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Here is a test I did with the 1 bar map sensor to see If I rear 1bar, and it didn't work to
I had the same test with the 2.5 bar T-Map sensor
the file
thats a 1 bar sensor in the scanner log right? If so it looks completely normal to me. Reads as 104kpa in the graph. Post a screenshot if your seeing something different but it looks aok to me.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
yes it's a 1bar for this one
I look at the tables display like you said, the pressure is Ok
but for the pressure but no the graph and the historygram the pressure isn't ok
Its because you have a custom pid setup incorrectly more than likely.
Close hptuners program, Go to your hptuners folder & delete your VCM Scanner.cfg file & then reopen this file and all should be well.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Fine the pressure is now PERFECT
but when I try to reconfigure some Historygraph tables
and the Insert Table is empty
It happened a couple of times in the past, and I didn't find the problem
Last edited by Garrett; 10-09-2007 at 01:45 PM.
Its because the scanner has no record now of the last vehicle you connected to. Go out to the vehicle in question, connect to the vehicle, open the scanner & hit the connect button.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
fine I will try it tonight
thanks alot for your help
The pressure in the graph now work
but in the main spark histograms no
I don't understand why
I attached the screen shot and the scan file
Because you setup your histogram incorrectly. Notice you have the X header referencing psi rather than kpaOriginally Posted by Garrett
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
lol
thanks alot
it works