Just curious what methods you guys use...what you all think works out best??
I have a histogram set up to read maf airflow vs. output frequency....just copy and paste.
Any better methods to use??
Just curious what methods you guys use...what you all think works out best??
I have a histogram set up to read maf airflow vs. output frequency....just copy and paste.
Any better methods to use??
I always setup a filter so im not screwing up a portion of hte maf table where the VE table might come into play, for LS1's a 4000+ cutoff is good so LSJ's would probably be the same. Then just use copy & paste(as long as your using a wideband & afr error histogram)
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
sounds good......so you filter out anything over 4k rpm? I have do have an AFR error histogrem set up with an innovative LM-1.
here's a copy of the config. I use.....that look good as far as the MAF error and everything?
anything UNDER 4000 rpms.
Generally under 4000 rpms VE & maf are both doing a part in controlling fueling.
After 4000 rpms the maf usually takes over completely.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
ok, that makes sense, thanks