What sensor do I use for dynamic cylinder air?

[Timonator]

What sensor do I use for dynamic cylinder air?

[Timonator]

I want to set up cylinder airmass on my chart and I can't figure out how.

[my_bd]

it should show up in your pid list if it is supported by your pcm.
see sample below...

only shows up on mine when disconnected from the car.
I guess my pcm does not support dca

weirdness

[Timonator]

Yes,It's in there,but how do I configure it for my chart?

[Bill@HPTuners]

Right click on the chart-chart settings, then choose where & what you want to add/delete.

[Timonator]

Right click on the chart-chart settings, then choose where & what you want to add/delete.

I try to do that by choosing cyl.airmass from the PID list.But don't I need to choose a sensor as well?Or a min./max setting?

[Timonator]

Ok never, mind it doesn't seem to need a sensor or anything.