Have set at 640 what about charts?? what should I do zero all out???
Have set at 640 what about charts?? what should I do zero all out???
anyone!
What charts??
Are you referring to the maximim torque vs gear tables or trans torque reduction tables??
Ken
what charts do u fool with to get rid of Torque management????
Engine
Set your Max Engine Torque vs Gear to 640
(If 1279, already disabled from factory. 1279 and 640 will yield the same result)
Set your Max Engine Torque constant to 640
Enter abuse mode test > 8000
Enter abuse mode test < 1
Automatic Trans
Trans Abuse Mode enabled "No"
Torque Reduction vs Torque vs Shift tables to Zero
Ken
thanks!
So what happens if I have the torque set at 640, the max torque at 640
BUT.................................
The RPM> 7000
Speed<255 MPH?
Retard in degrees at 9 13 16 19 21 23 24 26 27 29 30 32 33 34 35 36 37 38 39, Etc. Will this change timing with the upper conditions?
Is TM still enabled????????
And.....
Abuse mode at true
1200 RPM
5 % TPS
255 MPH
Was this torque management still active?
Torque reduction set at 0 - all the way across.
Abuse mode at true
1200 RPM
5 % TPS
255 MPH
I believe it should be set to:
Abuse mode to false
0RPM
0%TPS
0MPH
That's how I set mine.
Originally Posted by Ken@HPTuners
Question...
Is Max Engine Torque vs Gear the same as Max Engine Torque vs RPM vs Gear?
Is Max Engine Torque constant the same as Max Torque?
Where is the abuse Mode test? Is it "Drivetrain Abuse Mode"?
What about the Max Torque vs RPM? Does it need to be changed?
Thanks,
My C5
Ken I have done what you have listed above but have a question.
Will it still drop timing to -10 degrees on upshifts with the tables zeroed out but the -10 left in place for the Engine>Spark Retard>Max KR vs RPM
I'd like to have some trans TM at WOT shifts but at no other point.
Cheers
Chris