Torque Reduction vs Torque vs Shift

[jimmyblue]

What are the units on this table? Are they a % reduction
to the torque? The values get clipped to 100 if over, so
I am assuming this is the case. But would like to know.

I am trying to set the TM to limit torque during shift
to 300lb-ft and see how that goes.

[Chris@HPTuners]

yes this is the percentage torque reduction desired during the shift. The higher the percentage the more timing it pulls. This value is then used against a torque management retard table (not in the editor) that pulls the appropriate amount of timing to achieve the desired % reduction.