Not up to speed with all the lingo, so I'll have to use
general descriptions for this question...
When I connected to my truck today for the first time,
I had the the USB plugged into the little box that fits
between your computer and the OBDII connector and
then to my laptop as well as to my truck.
And, I turned on the key to my truck...and then read
the instruction on the screen that said "don't connect
to OBDII yet"
Apparently, the software was updating the firmware
for this little box thingy (what is this called again?)
So, is this going to hurt anything?
When I realized what I had done I waited until the
firmware update was done...then turned off the
key, then I connected again and was able to read
my entire VCM