I'm trying to make a virtual dash I'm going to use the auto tap cable and program. Can anyone help me with some commands I would need to acomplish my task?
Any help would be appreciated
I'm trying to make a virtual dash I'm going to use the auto tap cable and program. Can anyone help me with some commands I would need to acomplish my task?
Any help would be appreciated
The autotap program itself lets you build a virtual dash. You can pick whats being monitored, view it as gauges, tables or graphs, and pick the colors you like.
Business Network Solutions - for all your PC, network, printer and computer security needs.
Hi Josh,
What virtual guages are you after?
Boost, RPM, Transmission temp?
Paul
P.S. The Canadian "WGIobdii" program also has guages and graphs.
http://www.funddealernet.com/wgiobdii
se thats the thing I want wierd guages like oil pressure, tranny temp, Air intake temp, Tach, knock, fuel pressure, oil temp.
and does anyone know of a websight selling the autotap the cheapest. and what are the system requirements for this?
If they aren't monitored by the PCM then you wont be able to pull them from the port. If they are, then the extended OBDII stuff should display it.
Oil temp, tranny temp, and oil pressure I dont know about being monitored.. but the others are no problem. You can use it in a virtual dash, and even datalog it so you can look at it later.
Business Network Solutions - for all your PC, network, printer and computer security needs.
From the GM Extended PIDs I see that the following is availalable.
As you can see from the list, all items not covered in the generic PIDs, is covered in the extended.
All you need to find out is the PIDs for the GM Entended.
When you find them, tell me what they are.
Paul, ([email protected])
Knock Retard
Knock Sensor
Knock Sensor Active Counter
Knock Sensor Minimum Learned Noise
Knock Sensor Noise Channel
Knock Sensor Voltage
Knock/Octane Adjust
Transmission Diagnostic Code Set
Transmission Fluid Temperature
Transmission Input Shaft Speed
Transmission Input Speed
Transmission Oil Life
Transmission Oil Temperature
Transmission Output Shaft Speed
Transmission Output Speed
Transmission Pressure
Transmission Range
Transmission Range
Transmission Range Range
Transmission Steady State Clutch Slip Speed
Transmission Temp
Transmission Temp Sensor
Transmission Temperature
Transmission Temperature Sensor
Fuel Cutoff
Fuel Injection Pump Injection Angle
Fuel Level
Fuel Level
Fuel Level Sensor
Fuel Level Sensor Right Tank
Fuel Pressure (Gage)
Fuel Pump Ckt. History
Fuel Pump Ckt. Status
Fuel Pump Relay Circuit History Status
Fuel Pump Relay Circuit Status
Fuel Pump Voltage
Fuel Pump Voltage Feedback
Fuel Rate
Fuel System Status Bank 1
Fuel Tank Level Remaining
Fuel Tank Pressure
Fuel Tank Rated Capacity
Fuel Temperature
Fuel Trim Cell
Fuel Trim Cell Bank 1
Fuel Trim Cell Bank 2
Fuel Trim Index
Engine Oil Life Remaining
Engine Oil Pressure
Engine Oil Temperature
Again I was wondering about sights that sell kits like the autotap or is autotap the only company that sells it.
Wat software bundle do I need the extended or the normal simple one?
Here is a link to the one I use.
http://www.funddealernet.com/wgiobdii/wgiobdii.asp
http://www.funddealernet.com/wgiobdii/wgiobdiihw.asp
It is made in Canada.
Paul