-
Tuner
P0340, CMP sensor circuit malfunction
hey guys just got this code recently in my car. it still feels fine. its an 05 manual with 25k on it. i modified the VCT a bit to make more power. i retarted the cam timing up top. here is the bottom right corner of my VCT angle open vs Load graph.
7.00 6.61 7.23 8.13 9.00 this is .6 load and starts at the
7.00 7.58 7.51 10.00 15.00 3750 block for rpm.
2.50 4.00 5.00 11.5 15.00
2.50 4.00 5.00 11.5 15.00
obviously i dont wanna mess up the VCT system and am concerned about this code. anyone have experience with this, ignore it? change it back? thanks.
-
Tuner
Last edited by mustangjonGT; 06-21-2009 at 01:45 PM.
-
Tuner
This code can come up for various reasons, from too much of a difference between cams to a typical alternator failure.
Can you datalog cam angle with HPT? so you could see if you are getting what you are commanding.
-
Tuner
i dont think i can datalog it. i dont even think there is a PID for it on the scanner. is it still safe to beat on?
-
Tuner
You can datalog Cam Angle, Cam Angle error, Cam duty cycle, Cam 2 Angle, Cam 2 Angle error. It's in the PID list:Engine/General.
-
Tuner
cool, I could not make the datalog work with my car the couple times I've tried, it always give communication error.
-
Tuner
where the hell did you find those PID's? the hp tuners scanner sucks. there is like 8pids. can u tell me how exactly to datalog that?