"A6 Help" After 3600 converter install

[Bry9]

After installing Yank 3600 2006 C6 A6... The car leaves the line hard for about 3ft. then falls on its face, and then recovers..

Any help would be greatly appreciated...

[madvette08]

Can you post up your tune file.

thanks
Ian

[Bry9]

ok.. here it is

[madvette08]

Thanks having a look at it now.

Ian

[madvette08]

Have a look at this tune file just the tranny settings, its setup for a 3600 stall converter, only difference is it has 2.73 gears and its a 08.

Ian

[Bry9]

wont let me open it says "Index outside the bounds of array?"

[madvette08]

Sorry its because i have beta, ill post up some screen shoots of what i have done to the tune.

Ian

[Bry9]

thanks..

[madvette08]

Heres what i did with the TCC settings, i did this Normal, Pattern A and Pattern B and TUTD if you the paddles at all. I also bump the shift pressures up 10 psi in Base shift pressures X, Y and the max line pressure and brought all the base shift times down to .2002.

Ian

[HNK]

Heres what i did with the TCC settings, i did this Normal, Pattern A and Pattern B and TUTD if you the paddles at all. I also bump the shift pressures up 10 psi in Base shift pressures X, Y and the max line pressure and brought all the base shift times down to .2002.

Ian

Ian

I am helping a friend with his A6 06 modded Tranny with yank 3000, would your tranny settings work fine for that as well? His will end up with high SC boost.
What changes would you have to do if a stock torq converter was in use?

thnx

[Bry9]

Im still having issues, when I use ET street tires (slick).. The car falls flat upon launch,then recovers quickly,and takes off? Also sometimes it will not shift 2-3 without letting off throttle?

[MMGT1]

(Shift issue)Bry, are you compensating for the tire change in your tune? Also, do you have your shift speeds matching in both Normal and WOT at 100%? In Normal Shift even make the last two colums match your WOT shift points.
(Launch issue)Throttle Cracker table a little lean?