Windows 7, New laptop, 2.23 beta, Still cant get it to work....... Im without a car until this is fixed.......
Windows 7, New laptop, 2.23 beta, Still cant get it to work....... Im without a car until this is fixed.......
2007 C6 coupe LS3 416 6 speed mn Z51 3LT
Vararam Snake charmer 160 Stat
Kooks 1 7/8 headers with jet hot
Fast 102 ported intake 102 TB RPM Level 5 T56
MGW short throw ZIP 4.10 Severe Duty rear
RPS TWIN DISC CARBON CLUTCH CCWs ele wp
RPM LEVEL 5 TRANS W/HARDENED OUTSHAFT
http://www.youtube.com/watch?v=PtOPy_lp2QY
10.66 1.47 60ft 133+mph
Can I just use the 2.22? Is this an issue with 2.23? Every link I find for easy msi editor takes me to another link thank does nothing. Im chasing my tail.......
2007 C6 coupe LS3 416 6 speed mn Z51 3LT
Vararam Snake charmer 160 Stat
Kooks 1 7/8 headers with jet hot
Fast 102 ported intake 102 TB RPM Level 5 T56
MGW short throw ZIP 4.10 Severe Duty rear
RPS TWIN DISC CARBON CLUTCH CCWs ele wp
RPM LEVEL 5 TRANS W/HARDENED OUTSHAFT
http://www.youtube.com/watch?v=PtOPy_lp2QY
10.66 1.47 60ft 133+mph
See my previous post of how it worked out for me, I cant tell you about others. I use 2.22, removed the framework 4, installed, would not allow me to save so I run both editor and scanner on XP compatibility mode and it has worked great. My next Windows update it reinstalled framework 4 and still works fine on the XP compatibility mode.
Hope this helps, I am not a computer expert.
Carlos
1999 Corvette Coupe LS1 A&A Vortech V3SI A4
2012 Ford F150 Ext Cab Ecoboost
2002 Corvette Z06
I've finally gotten around to hooking up my desktop out in the garage I plugged in the module between the computer and the truck, turned on the truck, and successfully downloaded the PCM file onto the desktop. I then brought the desktop back into the house. I use a separate computer out in the garage that I normally hook up to the truck and is running HP Tuners successfully. I can open the file that I loaded directly from the PCM to the house desktop, but if I save a file to a USB storage device using the normal computer in the garage, I cannot open the file using the house computer. Why not?
Also, the garage computer is Vista 32 and the home computer is windows 7 32. The garage computer will open the file that was loaded directly to the house computer, saved onto a USB drive, but not all parameters are available. For example, I go to engine size, and it only gives me cylinder volume, without showing engine options (6.0L).
Thanks,
Ian
My win 7 won't open an emailed file either. It says "outside of the array". I tried running in compatibility mode and the vcm scanner will, but vcm editor says "non compatible software" and has no suggestions to correct issues.
when I tried getting license, it said I already had it...
just bought a new 17" laptop and have same install issues as everyone. ive email support to see if my 'new' laptop will be useful to me....grrrr 800 bucks in a new laptop and i cant log!!!! sheesh. friggin windows 7 64bit...hahahha