Im just getting the nova ready to run and i need to know what i have to tune out to run my powerglide? The harness i used was out of 2001 ws6 m6 i deleted everything i didnt need like Maf,egr,ac,Bcm Just wondering what i need tyo do to run this glide thanks alot
1963 Nova SSComp backhalf,6.0l with l92 heads,L76 intake s488 turbo
if it were mine i would just see what codes pop up and start turning them off till there is no check engine light.
2017 camaro ss a8 with low mount twins
You only need to disable manual CAGS from transmission section. Then set the P0801, P0803 and P0804 to "No error reported"
The PG (with manual or auto valve-body) will be seen by ECU as a manual transmission, and since the ECU and harness is from a M6 car, it will work fine. You need to adapt a speed sender to send the VSS signal to the ECU.
I assume you have all the mechanical stuff figured out...
Regards.
Reply With Quote