Feeling empowered after watching Calibrated Success, I watched the video for a third time in start/stop/do-exactly-as-told mode. I built each custom pid and table (I think) as was explained in the video. I am using an Innovate LM-2 WB connected with the proper analog cable to my Pro interface. I start the target vehicle and am rewarded by the lambda display in my EIO. Regardless of what I do, the PIDs for Lambda_err and Calculated Lambda gray out and show "unsupported parameter."
I am at my wits end with this thing and my laptop nearly entered lunar orbit after my last effort. Can anyone see what I'm doing wrong with the enclosed config file?
While I'm seeking help, in the section of the video where Greg shows the setup of the Lambda meter, he shows the output of the meter, then simply shows the equation of voltage/4 + .55. Can anyone explain where he got the '4'? Answers to these questions would hopefully get me on my way.
Thank you in advance for your help.