I have had my interface for around 3 weeks, and i have noticed when i do any kinda of logging, or leave it plugged into the obd2 connector for five mins, It will get very hot. I used my raytech today and it said 138 degrees. Is this normal?
I have had my interface for around 3 weeks, and i have noticed when i do any kinda of logging, or leave it plugged into the obd2 connector for five mins, It will get very hot. I used my raytech today and it said 138 degrees. Is this normal?
Can nobody tell me if their interface is doing this? I don't want to keep using mine and causing more damage to the unit if it isnt normal.
Mine gets warm, but I don't know about 138 degrees
Kenne Bell Supercharged 2003 Corvette Z06
I zapped it yesterday after roughly a 6 min run and it was 138. Also had kinda a "burnt electronic" smell to it. then it quit logging. it give me error everytime i tried to log again, then I reset my config in the interface and it worked fine again, aside from the heat.Originally Posted by umrjmac
The first few times that I used mine, it smelled like "new electronics", but I haven't noticed it since then.
I haven't had it stop in the middle of logging. If I were you, I would wrap these questions up in an email to support to get a firm answer with some data/experience behind it.
Kenne Bell Supercharged 2003 Corvette Z06
email support, sounds like something might be wrong with your interface.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
OK, I'l have to email support as soon as I get home. Thanks.
email sent
Thanks
Reply With Quote