Scanner: Support for ISO-Protocols (OBD-II)

[BlackZJ]

Hi

I read in this forum that your scanner will support ISO-Protocols soon. Since that thread is a bit older, I wonder if this protocol is already supported in the latest beta? If not, when will it be available?

Thanks,
Mat

[Bill@HPTuners]

Not supported yet(requires a firmware update that we are working on).

[BlackZJ]

Not supported yet(requires a firmware update that we are working on).

So I suppose there's no ETA, right?

[Bill@HPTuners]

Same time Dodge software is released as the firmware should be in the same build(dodge's require a firmware update)

[BlackZJ]

OK, I understand.
When do you expect it to become public beta?

[digitalsolo]

Looking forward to this. ISO support should allow me to scan my OBDII ('96) BMW. That'd be quite handy.

[BlackZJ]

Looking forward to this. ISO support should allow me to scan my OBDII ('96) BMW. That'd be quite handy.

Were they already OBDII in 96? My '97 Mercedes E-Class were not. Anyway, as soon as ISO is supported, most of the older OBDII vehicles can be scaned. Or at least it SHOULD work.

[digitalsolo]

Yeah, my E36 is definitely OBDII.

[BlackZJ]

Is the ISO protocol supported in the latest beta?

[Bill@HPTuners]

I don't think so, give it a shot if you already have access to it.

[BlackZJ]

I don't think so, give it a shot if you already have access to it.

Doesn't work...
A small window appears for a split second (to quick to read something). After a couple of seconds, it tells me that the ECM couldn't be found. One time it could connect but it wasn't possible to read any data.

I suppose that there's no ETA for ISO support. Right?

BTW. Is there an ETA for JTEC read support?

- Mat

[Bill@HPTuners]

Its a low priority right now-ISO that is.

No eta on JTEC read support at this time.