i dont get it.. i went back to stock, had to put in some new sensors, and then after a week i start getting a lean code, but its NEVER lean so i dont understand.
do i have to maybe change the lean/rich values a bit higher and lower in the fueling/o2 tables (e67 pcm) and should this ever even have to be done?
check your MAF scaling
384whp/303wtq
Built 2.0LSJ: TVS w/2.6, 1000cc, Stage 2 cams, custom fuel system, E85, Dual Pass, 3"intake, 3" Catless exhaust, CIA midlength Header
That code pops up when your trims pass a certain point to maintain stoich. You may never see lean on your wideband, but it is adjusting the fueling so much it throws a code.
Check your trims.
Kevin
awesome.. thats what i thinking.. my trims are wayy outa line right now.... i knew that from when i put the stock tune back on with the full exhaust... i just didnt think it would throw a lean code...
thnx
Reply With Quote