Originally Posted by
04colyZQ8
here are the dtc codes I had;
[ECM] P0315 - Crankshaft Position System Variation Not Learned (SES) (Pending) (Old) (History) (Current) (Immature)
[ECM] P0449 - Evaporative Emission (EVAP) Vent Solenoid Control Circuit (Pending) (Old) (History) (Current) (Immature)
[ECM] P0480 - Cooling Fan Relay 1 Control Circuit (Pending) (Old) (Current) (Immature)
[ECM] P0481 - Cooling Fan Relay 2 Control Circuit (Pending) (Old) (Current) (Immature)
[ECM] P0532 - Air Conditioning (A/C) Refrigerant Pressure Sensor Circuit Low Voltage (Pending) (Old) (History) (Current) (Immature)
[ECM] P2119 - Throttle Actuator Control Throttle Body Range/Performance (Pending) (Old) (History) (Current) (Immature)
[ECM] P0315 - Crankshaft Position System Variation Not Learned
[ECM] P0449 - Evaporative Emission (EVAP) Vent Solenoid Control Circuit
I used Hp tunners to turn the flags off for P0449 evap P0532 a/c, P0480, P0481, and P2119 throttle range performnce.
Then I reflashed and ran the engine the only code I got was P0315 Crankshaft Position System Variation Not Learned
I have the body control module and cluster hooked up from a 2007 express van, the engine is a 2007 express van 4.8L as well, I am using a 2006 SSR computer and 2006 SSR pedal, LS2 knock sensors, this swap will be going into a 2004 colorado.
I have the ebrake set light on the dash, and I have pin C1 32 brake switch signal connected to CHMSL supply 12 volts across these wires means brakes released, brake the connection and the brakes are applied.. I think?? So I broke the connection between those wires set the ebrake by grounding the light blue wire pin A7 at the body control module, ran the engine up to operating temp, and the case learn button will not high light, it says stop scanner? What does that mean and how do I high light the button? THanks! -Jamie