Help logging boost

[FIL131]

I have tried all of the formulas with baro and without.

Am I not doing something correctly here?

I believe I have a 3bar map and I know I am running the correct os.

This run showed no more than 2psi on my dash mounted guage but showed way more on the scanner, I didnt want to go any higher till I got it setup correctly.

Thanks guys

[Bill@HPTuners]

Log the 3 bar map pid as covered in the help file www.hptuners.com/help

[FIL131]

Dont know if I did something wrong but now my afr and boost are showing as unsupported parameters can someone take a look at this for me.

[robbyredneck]

you have to log the 3bar map pid. i log mine vs rpm in a histo then review it with the + so i see highest value. i also filter it so nothing below 0 is shown. my boost pid is, ([PID.2333]-101.7)*.145 , where pid.2333 is my 2bar map. i think bill told me once. if it's showing unsupported parameter that means the parameter is not supported.

[FIL131]

I am logging the 3bar map I followed the help instructions.

Can someone look at my configurations and give me some pointers?

[robbyredneck]

sorry i guess i did see that. i can't however see your user defined pid. are you trying to table display it or histogram log.?

[FIL131]

table histo and guage if I can

[Bill@HPTuners]

Probably an issue with your customer pid(s)

[FIL131]

Are you able to look at my setup and give me a few pointers I am out of ideas and ready to give up. If you dont I will start posting all over the place asking when 2.24 will be ready. lol. joking.

[Bill@HPTuners]

You would need to post the VCM Scanner.cfg file which contains your custom pids.

[FIL131]

You would need to post the VCM Scanner.cfg file which contains your custom pids.

I did in my first post, but I will post it again

[Bill@HPTuners]

That is one of your config files, the file named VCM Scanner.cfg is the one that stores your custom pids.

[FIL131]

That is one of your config files, the file named VCM Scanner.cfg is the one that stores your custom pids.

Sorry I guess I didn't understand that the file was seperate from the scanner configs.

Here is the file you were asking about

[FIL131]

Also attached VCM Scanner.cfg to my original post

[FIL131]

T.T.T Where are you bill?

Is there anyone else who can look at my config?

[FIL131]

Still looking for help, have you had a chance to look at it Bill?

[edcmat-l1]

Still looking for help, have you had a chance to look at it Bill?

Bill is out of town for a week. Back around the 13th.

[FIL131]

TTT for Bill or another user willing to look at my config

[Bill@HPTuners]

Its reading boost just fine, delete your VCM Scanner.cfg file and then open the scanner and you will see this as well.

[FIL131]

Thank you Bill, hope all is well I know you were away for family reasons.