Need help with scaling 2010 camaro injectors.

[Tunerjunk]

First, thanks in advance to any that can guide me through this.

The build is a416ci LSX 80mm single turbo 18-plus#'s boost.

We have 125# 1000cc injectors and the injector tables are not like any of the gen3-gen4 I'm used to. No flowrate vs kpa, etc.

I have raised the flow rate vs pressure but the higher I go the more the short term fuel trims throw at it at idle so I'm lost.

What I need is each of the tables I need to change, and a rough estimate where to t. I dont expect a complete tune....just guidance.

Again, thx in advance.

[BoostedYards86]

good luck

[Tunerjunk]

LOL! Thats what I'm finding. This is NOT an easy tune by any means.

[DSteck]

Yea it is. You just need to learn to apply some basic skills. There is still a flow rate table, it just references gauge fuel pressure instead of vacuum from atmospheric.