Hi everyone. I have a 2010 2500HD LMM and I am having issues hooking up my hptuners to the truck. It connects with the scan tool, but the editor will pull the ecm file but it fails a validation check and I cant edit it. I can save it also but cant open it. Both times its a file validation check?
Anyone else have this problem? Any solutions?
thanks
I hope someone can answer this. I have the same truck and the same problem. I took it to the dealer and had it flashed with Tech2 to verify it was a stock file. Still get Vailidation fail.
i was told to update to the newest beta version, no luck. same problem.
how did you update to the new bata version?
It was sent to me in an email. I have been going back and forth with support for awhile. Still no luck.
Give me a minute and i'll find the emails.
that was the first response, then I replied with everything needed. I got this as a reply from Mr Henn.
Please send me a vcm suite infolog while connected to the vehicle in question as shown in our demo’s below as well as the .hpt file in question so that I may further assist you.
Check out our Demos Here http://www.hptuners.com/forum/showthread.php?t=5058
Thanks,
William Henn
HP Tuners LLC.
www.hptuners.com
there is more to that reply but its just supported operating systems.Try reading with the newest beta
PLEASE READ THE ENTIRE DISCLAIMER FOR YOUR OWN SAKE!
Be sure to update to the newest windows & net framework software(net framework 3.5 SP1 & in ALL cases net framework 4.0 which can be found here http://www.hptuners.com/forum/showth...560#post252560) for the smoothest transition without crashes.
This beta adds several new features for several platforms
Adds read support for most 2003-2006 NGC3 Dodge, Chrysler & Jeep platforms, we ask that you read as many of these vehicles and send us the .hpt file and an infolog while connected to each.
Adds support for interfaces starting with 116xxxxxxx
Firmware update for SPI chip id conflict
All platforms receive
New Editor code
New Scanner code with ability to scan most late model Chrysler/Dodge/Jeep applications
Net Framework 4.0 standards
Net Framework checks removed
Multi vehicle upgrade credit bug fixed
Fixed Spark table axes for RXAQ6BA ford strategy
Added read support for 97 Cutlass V6
Added read support for 2009 Ford Fseries Strategy TENF1
E67 code fix
2012 E38 Operating system fix
I'm having the same problem on a 07 GMC gas 5.3L. Was told by Bill it was programmed by something else and needed to be flashed with a Tech2. The customer had that done and apparently wasted his money because I get the same error after having that done. Can read file, save file, and get the error in the pic when you try and open it. And then they all leave for a week and provide no support.
yea. the Tech2 didn't work for me either.
exact same thing I get.
tried again today, no luck. Is this truck not even supported? Seriously, I hear others tuning their LMMs and I cant even hook up to mine.
A friend of mine said
So how would I go about using a known good file? Should I change the vin?Read entire. If no good do a write entire with a known good file. Only had it happen on my stuff that was already tuned up. Be careful cus you can brick it.
FIGURED IT OUT, DOWNLOAD THE NEW BETA VERSION 2.23
It so worked, omg its so long overdue. Finally, I can kill reduced engine power
Using the latest BETA as of 4/6/2012 did not solve my problem with the 07 Gas truck.
Reply With Quote