I was trying to "write calibration only" and hit "write entire" by accident. Well long story short it started the process and I hit abort. Now it cannot connect with my VCM and car will not start. Engine turns over but noticed fuel pump does not turn on.
I tried using a different scan tool I own and that also no longer connects to my PCM.
Any ideas?? sorry I tried searching the forums but couldnt find my answer. If by chance this PCM is now screwed...I have another one that was previously programmed for my car that I was going to swap in tomorrow and see the results. Will I need to use more credits to write this other one if it already is programmed and has worked for my car?
Thanks