HPT scan

[slow6]

plz allow me to display my scan
my VE - LTFTs were (+18 to +20) (lean)
so I went into my Primary VE and subtracted
the lean-ness (aka adding fuel cause its lean)
I took some timing out where I saw KR
you can see my edits in the file named "edited"

I copied the high to the low then took out + (-4)
from the low.

I'm now hearing not to tune useing the LTFTs, I
should use STFTs instead.

I need to purchase a wideband ASAP, would be alot easier.
I've seen my injectors get up to 70%
I've seen my MAF get up to 12 lb/min NA
thanks

http://www.geocities.com/jonathan_abilene/HPT.zip

[slow6]

how do I get a new calculated airflow VS TPS vs RPM table?

I said I was running a max of 12 lb/min on N/A.
It set off the P1514/P0068 code.

Think I can just copy someones table? probably not.
But it would be better than the table I have now.
I'm gonna go clean my dirty MAF sensor with alchol and Q-tip

[slow6]

should closed loop not be enabled until like 100F mines set way down at 68F

[slow6]

I want to get those 930-940 mV fueling
but dont know how to get there.