Okay I upgraded to some 60# Siemens high imperdance injectors and im having trouble trying to find out what exactly im suppose to change in my tune to properly tune these injectors and what values to use. If anyone has a good IFR table for 60# injectors please post it. Also let me know if I need to change more than just the IFR table. THANKS!
Injector Specs
Coil resistance: 12.5 OHMS/ High impedance/ High-Z
Static Flow Rate @ 43.5 psi (300KPA) w/Gas 60Lb/hr=630 cc/min=453 g/min
Static Flow Rate @ 87 psi (6000=KPA) w/Gas 85.7 Lb/hr=630 cc/min=900 cc/min=648 g/min
Gain: 0.11 ms/mg
Offset: 0.055ms
Turn on Time @ 14VDC:1.14 ms
Turn Off time @ 0.85ms @ 600 KPA
Connector: Bosch EV1
Series: Deka 4 (Deka IV)
Orifice Type: Multi Orifice
Spray Pattern: 30 degree spray cone
Factory fitted with Viton upper and lower o-rings
Here is my current tune....