Page 5 of 5 FirstFirst 12345
Results 81 to 83 of 83

Thread: Dodge Viper Gen3 (JTEC/JTEC+) and Gen4 (Venom) tuning

  1. #81
    Potential Tuner
    Join Date
    Dec 2018
    Posts
    1
    Hi.. Any news about jtec and jtec+ tuning... I have the mpvi2 interface and nothing.. I think just read on gm serial and can bus... But nothing on sci and pci bus of dodge and jeep protocols... Very bad folks

  2. #82
    Potential Tuner
    Join Date
    Oct 2019
    Posts
    1
    I?ve made an immobilizer delete solution for a 2005 Viper SRT-10 8.3L and would need to delete some fault codes as the engine is going to be retrofitted without some emissions related sensors.

    My question is that if I have read AB28F200B5B flash memory from the GEN3 pcm with a Beeprog2 programmer, am I able to modify the firmware with VCM and export it as a complete binary file and write to the flash memory so that checksums are corrected and car starts? I don?t mind if it cannot be read via diagnostics but atleast it would be great to have the PCM firmware modified.

  3. #83
    Does datalogging work for JTEC STR10 ? i was able to read and open ecu rom, but not able to datalog anything at all with mpvi2 cable ...