Looking for function parameters for wideband through a/c

[tweeder]

I used their thread

http://www.corvetteforum.com/forums/...hp-tuners.html.

I put in the values that he said. The wideband shows up in my chart but as soon as I start logging, it disappears. I was thinking after that mabey my 3800sc has different numbers to go in there. I have the plx gen III wideband. I took the one wire and put it into the PCM where the a/c pressure switch would go. Any help.

[tweeder]

just a small update, i had the wrong sensor. it said volts but i switched it to a/c, i hope thats right. I hooked it back up and there was no change, it disappeared again. here is my cfg.

[tweeder]

just a small update, i had the wrong sensor. it said volts but i switched it to a/c, i hope thats right. I hooked it back up and there was no change, it disappeared again. here is my cfg.

Bump

[CatnipG5Bandit]

Try this config. My wideband is probably different from yours though. You'll need to add a different offset from mine.

[tweeder]

Try this config. My wideband is probably different from yours though. You'll need to add a different offset from mine.

Thanks will give that a try