Off Board Programming 2010+ E38 with SPS

[Camaro68]

Reddevil96, would you share the BCM pinout you use to to program an ECM?

Thanks

[TheMechanic]

Just performed a replace and program with Techline Connect on a 2011 E38 ECM in my stand alone system. I did have to add a 120 ohm resistor in the CAN circuit. Went right through.

[TheMechanic]

Just performed a replace and program with Techline Connect on a 2011 E38 ECM in my stand alone system. I did have to add a 120 ohm resistor in the CAN circuit. Went right through.

Well just tried a new E38 12625455 service number and it was a no go with SPS as a replace and reprogram. Guess I will have to look at integrating a BCM into my off board programmer. Anyone with additional info let me know.