This is the VCM suite info 2.24.1165, should be the latest version.
This is the VCM suite info 2.24.1165, should be the latest version.
2006 Escalade LMM Duramax Tuned
2000 S10 Twin Turbo 6.0L
56 GMC 100 Status Unknown
So after all this, I uninstall VCM Suite and redownload and install and wooohooo, 105kpa 3bar sensor in the MAP 3bar PID.
2006 Escalade LMM Duramax Tuned
2000 S10 Twin Turbo 6.0L
56 GMC 100 Status Unknown
Check it out, MAP reading good, IAC count much better, and everything else is starting to come together.
2006 Escalade LMM Duramax Tuned
2000 S10 Twin Turbo 6.0L
56 GMC 100 Status Unknown
2004 Vette Coupe, LS2, MN6, Vararam, ARH/CATs, Ti's, 4:10, Trickflow 215, 30# SVO, Vette Doctors Cam, Fast 90/90, DD McLeod, DTE Brace, Hurst shifter, Bilsteins etc. 480/430
ERM Performance Tuning -- Interactive Learning ..from tuning software training to custom tunes
HP Tuners Dealer- VCM Suite (free 2hr training session with purchase), credits and new Version 2.0 turtorial available
http://www.ermperformancetuning.com
http://www.facebook.com/ERMPerformanceTuning
[email protected]
I couldn't tell you, but I hooked up my wife's escalade (running 2bar OS and map) KOEO scanner showed 0kpa, bump starter and 50kpa. I know her truck is right and has always been right since converting, so uninstall, re-install and 0kpa KOEO, Flippin ready to throw all electronics but then one last hope, bump starter and there it is, 105kpa in the 2bar MAP PID! Over to S10 and exact same. Going to wrap everything up tomorrow and start logging and dialing it in. Thank you for all the hours and help you provided.