cp-the-nerd_09-Malibu-LY7_v3.55.hpt
I've changed the enable/disable rpm to 1300/1000 for better access (it was 1600/1200 stock). Enable speeds are fine. I've dropped the blend time from 150 across the board to 50, raised the entry spark (this is the correct way to get it to enable sooner, correct?), and dropped the Fuel Cut Delay significantly. I'm still looking at 4-5 seconds before DFCO kicks in on highway coast/decel.
Any input is appreciated. I haven't touched CylAir because I haven't been able to find any good info on it. Haven't touched throttle enable/disable either.